WHAT IS THE BEST WAY TO FIX A BROKEN LED LIGHT IN THE INSTRUMENT CLUSTER?

What is the best way to fix a broken led light in the instrument cluster? In the event that the led light bulb in your instrument cluster is malfunctioning, you run the risk of missing out on information that you will need while you are driving. Prior to the next time you drive your car out on the road, you should repair any bulbs on the cluster that are not functioning properly if you find any that are malfunctioning. You should be able to get these replacement LED bulbs at the auto parts shop in your neighborhood. instructions 1. Raise the hood of your car and look up. In order to release the clamp bolts that are attached to the negative and positive terminals, you should use a wrench gently. First, disconnect the battery wires from the terminals that correspond to them. 2 Step into the driver’s seat and look for the tab that is located behind the steering wheel. This tab will enable you to adjust the height of the wheel’s position. To make the steering wheel as low as feasible inside the steering column, move it to its lowest potential position. 3) Locate the rubber bezel that is located around the perimeter of the instrument panel. To remove the two screws that are holding it in place, you may use a screwdriver with a Phillips head. Remove the bezel from its position around the dashboard. 4 It is necessary to remove the three screws that are used to secure the instrument cluster to the dashboard. Put the cluster in the middle of the dash and move it out. Unhook the electrical connection by accessing the area behind the cluster and reaching around. Position the cluster on a surface that is free of clutter. 5 Remove the broken bulbs from the panel by unscrewing them in a counterclockwise manner until they are in a free position. You may replace them with new bulbs by placing the new bulb in the same location as the old one and twisting it in the opposite direction. Take the bezel and the instrument cluster and reconnect them. The battery wires should be reattached to their appropriate terminals, and the engine should be started in order to verify that the new lights are functioning properly on the cluster. dreambox dm7080hd dm7080hd dm8000hd led wall washer light dm8000 dm7080 hd dreambox dm8000 hd dm8000 hd dreambox dm7020 hd 7020 hd dm7020 hd dreambox dm500 hd dm500 hd v2 dreambox dm500 hd dm800 hd se v2 dreambox dm800 hd se v2 dreambox dm800 hd se dreambox dm800 hd se dreambox dm800 hd se dreambox dm800 hd se dreambox dm800 hd se dreambox dm800 hd se dreambox dm800 hd se and dm800 hd se dreambox