IF YOU WANT TO REMOVE THE LED CIRCUIT FROM THE FLASHLIGHT, HERE IS HOW TO DO IT:

Where to Find the LED Circuit in the Flashlight and How to Remove It The beam that is produced by LED flashlights is both brighter and more powerful than the beam produced by its incandescent bulb-using counterparts. In contrast to a bulb, the light-emitting diode (LED) does not screw into the flashlight; rather, it is coupled to circuitry that functions to provide it with power and to regulate the intensity of its light. You will be able to use the LED for other projectors if you remove it from the circuit board to which it is connected. For the removal to be successful, it is necessary to have a delicate touch and the skill to use a soldering iron in a closed area. In the event that you have no prior expertise with soldering, you should not remove an LED from a flashlight. Instructions 1 Arrange some newspaper on a table and set it down. Take off the cap that covers the battery of the flashlight. Taking the batteries out of the battery compartment is the first step. 2 If it is feasible, remove the reflector from the front of the flashlight by unscrewing it. If this is not possible, hold the flashlight in one hand while grabbing its front and using the pliers in the other hand to twist the two shells apart. 3. Set down the reflector or the front portion of the flashlight in a separate location. Cover the newspaper with the flashlight’s body, which should include the circuitry that is contained inside it. 4 Make sure that the body of the flashlight is held down with your left hand (reverse this for “lefties”). Using the needle-nosed pliers in one hand, take hold of the circuit board that is located within the body of the flashlight. Extraction of the circuit board from the body of the flashlight should be done with care. Placing the circuit board on the newspaper is the next step. The soldering iron should be heated up. The tip of the soldering iron should be applied to the sides of the metal bucket that is around the LED. In order to remove the metal bucket from the circuit board, you will need to use the needle-nosed pliers to grab it. Take the newspaper and place it on top of the metal bucket. 6 Utilizing the soldering iron, begin by heating the bottom of the metal bucket. The LED should be carefully grabbed with the tweezers, and then it should be pulled up and out of the metal bucket. Place the LED on the newspaper and set it down. With the help of the tweezers, you should straighten out the two conducting pins that are coming from the LED. Dreambox DM7080HD, DM7080HD, DM8000HD, DM8000 HD, DM8000 Dreambox DM8000 HD, DM8000 HD, DM8000 dreambox DM7020 HD, 7020 HD, DM7020 HD, DM500 HD, DM500 HD V2, Dreambox DM500 HD, DM500 HD V2, Dreambox DM800 HD SE V2, Dreambox DM800 HD SE V2, Dreambox DM800 HD SE, Dreambox DM800 HD SE, Dreambox DM800 HD SE, DM800 HD SE, Dreambox DM800 HD SE, DM800 HD SE, DM800 HD SE, Dreambox DM800 HD SE, DM800 HD SE, DM